Products > Kits>Eagle Dual Pressurized Above Dash HUD Kit
The Pressurized Dual Eagle kit has two chevron style displays and two HUD adapters. With the chevron display, when you come in for a landing you want to fly to the blue donut (on speed for landing). Should you come in with too low of an angle of attack, the yellow chevron will light up and tell you to put your nose up. Should you come in with too high of an angle of attack, the red chevron will light up and tell you nose down. This kit comes with the Switch Panel Pre-Mounted in the Above Dash HUD (Heads Up Display) adapter kit.
The HUD is a self contained adjustable beam splitter adapter that mounts to the lip of the Eagle display and turns the Alpha System AOA into a true HUD. Intended for placement directly within the pilot's peripheral vision. Allows for instantaneous viewing of AOA information exactly where needed. The HUD glass is an enhanced color correcting, anti-glare lens. Comes complete with mounting frame, base adaptor plate, dome, display brackets and hardware.
Dual Above Dash HUD Pressurized Kit Part #: DSTR-AOA-9600DPK-(ADH)
|
|
Complete Kit Weight | Less than 3.00 lbs. Click here for full list. | |
AOA Interface Module size | In Inches: 5.75 x 2.60 x 1.65 | |
System Voltage Requirements | 12 - 28 Volts DC | |
System Max Power Draw | 0.250 Amps | |
System Power Cable | 6 ft, three wires: power, ground and shield | |
Above Dash HUD Weight | 4.32 oz / 0.270 Lbs | |
HUD Frame Dimensions | L: 4 1/8" x W: 1.250" | |
HUD Base Adaptor Plate Dimensions | L: 4.613", W: 2.780" | |
HUD Dome Dimensions | L: 4.251", W: 2.407", H: .960" | |
Heated Probe Voltage Requirements | 12 or 24 VDC (must specify when ordering) | |
Heated Probe Power Draw | 86 Watts at 12VDC / 172 Watts at 24VDC | |
Heated Probe Current Draw | 8 Amps at 12VDC and 8 Amps at 24VDC | |
Heated Probe Power Wire | Supplied by others | |
Audio Output | 1 Volt P-P max at 300 ohm input impedance | |
Aux (Audio) Cable | 6 ft, three wires: AP audio, AP ground and shield | |
Audio Options | Four | |
Mute Switch | Yes, on switch panel | |
LED Brightness Levels | 16, from ultra dim to very bright | |
Photocell Diode | On display, allows for custom daytime/nighttime brightness settings | |
Pressurized Version | Yes |
Dual Pressurized Connection Diagram | Download |
Display Dimensions | Download |
Increasing AOA Diagram | Download |
Eagle Lift Curve | Download |
Display Segment Transitions | Download |
HUD Dimensions | Download |
HUD Base Adaptor Plate Dimensions | Download |
HUD Dome Dimensions | Download |
Power Cable | Download |
Switch Panel Cable | Download |
IF Module Extension Cable | Download |
IF Module AUX Cable | Download |
Dual IF Module Cable | Download |
Standard Probe Mounting Plate | Download |